This connector is designed to clip onto the end of our single colour 10mm COB LED strip to allow it to connect with a 12/24V power supply. The COB LED strip light must be 10mm wide to use this connector. Before this connector can be used, gel waterproof coatings must be removed 7mm from the end of the LED strip. The LED strip can then slide inside the connector, passing under the metal pins. The pins can then be pushed down using a pair of pliers to clamp the COB LED strip light in place. The wired connection can also be clamped in the connector, ensuring the teeth clamp directly onto the circuit board of the LED strip not the gel coating.
This connector can be used with our COB LED Strip Lights providing the thin waterproof coating is removed from the top of the copper terminals first. This can be done using a sharp blade or fine sandpaper.
This connector cannot be used with any other LED Strips.
This connector is approximately 150mm long.
This connector is only suitable for powering up to 5m of LED strip. To power longer lengths a soldered connection is required.