LED Driver 36 watts for indoor use only.
This LED Driver power supply can be used to power up to 36 watts of our 12 volt single colour and RGB colour changing LED Strip Lights. The driver features a 3 Pin UK Plug on the input cable for a plug and go installation and a 12-volt jack on the output cable. If required a 12V Female Connector can be fitted on the output to give a positive and a negative terminal for direct connection with our single colour LED Strip Lights. In the case of RGB Colour Changing LED Strip Lights, the 12V jack could be removed if the RGB Colour Controller is fitted with screw terminals allowing direct connection.
UK 3 pin plug may be removed by a suitably qualified professional and wired directly into 240V AC mains power via a fused spur to enable lighting to operate off the original light switch.
Specification
| Input Voltage | | 220-240 V AC |
|---|
| Output Voltage | | 12 V DC |
|---|
| Output Power | | 36 W |
|---|
| Output type | | Constant Voltage |
|---|
| Length | | 97mm |
|---|
| Width | | 45mm |
|---|
| Depth | | 30mm |
|---|
| Warranty | | 2 Years |
|---|
